CNC Milling insert (PVD Coated/diamend coated/carbide) RNM-200-R20/RNM-160-R10/RNM-100-R10 JC8003/JC8015s

CNC Milling insert (PVD Coated/diamend coated/carbide) RNM-200-R20/RNM-160-R10/RNM-100-R10 JC8003/JC8015s

  • deskar high quality hrc50° 1p 2f r8mm16×35×100

    DESKAR High quality HRC50° 1P 2F R8mm16×35×100

    Features: ① Blades high toughness, high sharpness, high wear resistance; ② blade TiALN (aluminum nitride titanium) coating, unique strength, reduce the use of cost, high hardness, high heat resistance, high stability.

  • hhip 6062-5001 t/nt-2r c5 coated right hand threading carbide

    HHIP 6062-5001 T/NT-2R C5 Coated Right Hand Threading Carbide

    HHIP C5 Coated right hand threading carbide insert is completely interchangeable with the Kennametal Topnotch and the Teledyne Firth Notch systems. Grade C5 /TIC-65 coated insert which is the same as the Kennametal KC810, KC850, KC950, KC730 grades. 60 degree negative rake, neutral insert.

  • deskar high quality hrc50° 1p 2f 8.0mm8×20×60 solid tialn cnc

    DESKAR High quality HRC50° 1P 2F 8.0mm8×20×60 Solid TiALN CNC

    Features: ① Blades high toughness, high sharpness, high wear resistance; ② blade TiALN (aluminum nitride titanium) coating, unique strength, reduce the use of cost, high hardness, high heat resistance, high stability.

  • apmt 1604 pder-h um25 carbide inserts for milling pvd coated

    APMT 1604 PDER-H UM25 Carbide Inserts for Milling PVD Coated

    Carbide Inserts for Milling PVD Coated Grade UM25 (P25–M25–K25 + PVD TiAlN Coating) Economy grade for general Steel, Stainless & Cast. Geometry H for Medium to Heavy Cuts.

  • pvd-coated carbide grade machining recommendations

    PVD-Coated Carbide Grade Machining Recommendations

    PVD-Coated Carbide Grade Machining Recommendations for Milling and Turning Hardness Milling Feeds should be in the range of 0.003 in/tooth to 0.012 in/tooth. Higher speeds require lower feeds, whereas, low speeds use higher feed rates. A good general starting point for feed rate in milling is 0.004 in/tooth. Turning Finishing: 0.003 to 0.015 in/rev

  • r590-110504h-nl h10 sandvik coromill® century, carbide insert

    R590-110504H-NL H10 Sandvik CoroMill® Century, Carbide Insert

    Sandvik 5747652, 69826220251, R590-110504H-NL H10 Sandvik CoroMill® Century, Carbide Insert for Milling, Uncoated